Số phát hành: Số 7 - Tháng 3 - 2026Khoa học - Kỹ thuật
Design and implementation of a front-wheel hybrid drive system for motorcycles using an electric motor
Xuất bản: tháng 8 4, 2026
Tóm tắt
This study presents the design, fabrication, and integration of an electric motor mounted on the front wheel of a SYM Attila motorcycle, followed by successful road testing. The modified vehicle demonstrated stable operation and enhanced acceleration relative to the original model, attributable to electric motor assistance under increased load conditions, particularly in urban traffic environments. The results indicate a high level of technical feasibility, with fuel consumption reduced by 13.2% per 100 km compared to conventional gasoline operation. At the same time, the hybrid configuration preserves extended driving range through the combined use of dual energy sources.
B. Asaei and M. Habibidoost (2013). Design, simulation, and prototype production of a through the road parallel hybrid electric motorcycle, Energy Conversion and Management, 71, 12-20.
2.
Huynh Thanh Banh & Pham Tan Tai (2023). A solution to converrt the Attila motorcycle in to hybrid gasoline-electric motorcycle. Journal of Industry and Trade, 4.
3.
K. V. Quang, L. D, Duy, T. V. Dang et al. (2022). Development of hybrid vehicle power combination system using CVT. Transport and Communications Science Journal, 73(6), 647-660. https://doi.org/10.47869/tcsj.73.6.4
Khaled Magdy (2018). Arduino Digital Potentiometer X9C103S Interfacing Examples. [Online] Avaiable at https://deepbluembedded.com/arduino-digital-potentiometer-x9c103s-interfacing-library-examples/
5.
N. T. Ha, P. T. Tai, T. T. Minh et al (2021). Research on integrating hybrid drive systems for motorcycles with electric motors located at the rear wheel. Tra Vinh University Journal of Science, 31, 49-57.
6.
R. Kumar, R. K. Pachauri, P. Badoni, D. Bharadwaj, U. Mittal, and A. Bisht (2023). Investigation on parallel hybrid electric bicycle along with issuer management system for mountainous region. Journal of Cleaner Production, 362, 132430.
7.
T. V. Dang, K. V. Quang, T. D. Quang et al (2022). Research design and manufacture of a power distribution control unit for hybrid vehicles. Journal of Maritime Science and Technology, 10, 202-210.
